Method not found: 'Int64 OpenDentBusiness.DataCore.NonQ

[wjstarck]

I can build my plugin project just fine against OD 7.6 with no errors. However, when I try to run it in OD I get:

Method not found: 'Int64 OpenDentBusiness.DataCore.NonQ(System.String)'.

right after OD loads.

All the references appear to be OK. Did something change that would cause this to suddenly stop working?

[wjstarck]

Hmmm, well, nevermind.

I remade some of the references and now it works...

[drtech]

I am having the same problem...when running in debug mode it works fine...when running a release version I get the error v7.7.7

[jordansparks]

You have to make sure all of your projects are building.

[Roy Bloom]

ACK my anesthesia plugin is having the same problem in 7.6....int64 ....what can I do I need this.

[wjstarck]

ACK my anesthesia plugin is having the same problem in 7.6....int64 ....what can I do I need this.

I've fixed this for Roy. He was using an outdated version of the plugin.

[drtech]

Yes, I figured out when compiling the project, it was not building a new version of my plugin and so I was ending up with an old version.

[Roy Bloom]

Thanks Dr. Starcks! It was a pleasure talking to you and look doers to purchasing this product in April. I still think there is a work around to Bluetooth the output from the EKG printer at 5 min intervals of the vitals using hyperterminal
Inal and criticare monitors. I now know two OMFS that do not despise me... Heh heh. I worked on autonotes from around 8 Friday morning to 2:30 Saturday morning. I can now click the whole note for all extractions and IV sedation that is the most inclusive since the notes I used to write in 1992-3 in the OMFS Fellowship. A set of thirds is now a page long typed progress note. Today working on IC for ext and IV in sheets and working out some kinks in autonotes as it was my first time use this feature.

Again Thank you..... And all the folks at OD that had to talk to me somany times overthe last few days.